Flying Tiger 10m

Flying Tiger 10m

Flying Tiger 10m

The Flying Tiger 10 Meter was first launched in 2006 and since then over 100 boats have been produced are sailing world-wide. One design fleets are established in the United States, Australia, Canada, and China with a new fleet movement forming in New Zealand. Designed and promoted as a family club racer, the FT 10 is built to stringent one design specifications with crew and sail limitations that keep cost of campaigning the boat at a reasonable level. Inexpensive to own, fun to sail, and quality construction make the FT 10 a standout in its class.

Designed by Robert H. Perry Built by Flying Tiger Boats, LLC

  • LOA: 32.68′
  • Beam: 9.12
  • DWL: 30.31
  • Draft: 7.61
  • Keel Up: 3.28
  • I: 39.28
  • P: 40.17
  • E: 14.90
  • J: 12.13
  • ISP: 48.28
  • Displacement: 4376
  • IJS: 19.13
  • Ballast 1918
Construction Hull and Deck:

Vacuum bagged fiberglass sandwich core construction. All interior bulkheads and furniture molded and cored fiberglass construction.

Deck:

  • Primary Winches #40 Harken, Aluminum Drum
  • Secondary Winches #16 Harken, Aluminum Drum
  • Spinlock Rope Clutches (5)
  • 8 inch Marelon Cleats (4)
  • Harken Adjustable Jib Leads
  • Plastimo Manual Bilge Pump Mounted in Cockpit
  • Stainless Steel Bow Pulpit with LED Navigation Lights
  • Stainless Steel Stern Pulpit with LED Navigation Lights
  • Stainless Steel Stanchions and Lifelines
  • Stainless Steel Handrails on Cabintop (2)
  • Stainless Steel Tiller with Carbon Fiber Tiller
  • Removable Rudder Blade in Cassette
  • Harken Winch Handles (2)

Interior:

  • Large V-Berth in Bow Section
  • Oval Opening Hatch above V-Berth
  • Salon with 2 Settee Berths, Chart Table/Sink and Galley Pump
  • 12V DC Main Electrical Panel with Breakers and Voltmeter
  • Quarter Berths Aft Under Cockpit (2)
  • Interior Lighting Storage Compartments under All Berths

Engine Compartment:

  • Adjustable Bracket for Lowering/Raising Outboard Motor
  • Compartment for 25 Lt. Fuel Tank
  • Compartment Vented with Electrical Blower
  • Engine Controls Recess Built Into Cockpit Starboard Side
  • Bridge Deck Hinged Hatch Closure

Mast and Rigging:

  • Mast, Boom and Prodder Carbon Fiber
  • 2 Sets Tapered Sweptback Spreaders, Aluminum Foil Sections
  • ¼” 1×19 Stainless Steel Standing Rigging, Continuous
  • Adjustable Backstay
  • Facnor Jib Roller Furler
  • Main, Jib and Spinnaker Halyards
  • Main, Jib and Spinnaker Sheets
  • Main Outhaul, Cunningham and Boom Vang
  • Keel Hoist
Manufacturer reserves the right to change specifications without notice